Locking the rotary handle assembly – GE Industrial Solutions Record Plus TDM, NEMA 4__4X: FC100 User Manual
Page 6
Locking the Rotary Handle
Assembly
Push the slider down to
”OFF”
position of breaker
and insert the padlock shaft 0.2 in. (5 mm) to 0.315
in. (8 mm) into the slot in the padlock lever, to
prevent closing of the breaker during maintenance,
illustrated in Figure 11.
Padlock Lever
Figure 11. Locking the breaker operating mechanism during
emergency.
These instructions do not cover all details or variations in equipment nor do they provide for every possible
contingency that may be met in connection with installation, operation, or maintenance. Should further
information be desired or should particular problems arise that are not covered sufficiently for the purchaser’s
purposes, the matter should be referred to the GE Company. The circuit breaker is a sealed unit that contains no
user-serviceable parts. Tampering with the seal will void the warranty.
g
GE Consumer & Industrial
General Electric Company
41 Woodford Ave., Plainville, CT 06062
www.geindustrial.com
DEH40913 R02 0404
© 2004 General Electric Company