GE Industrial Solutions NH050x-L Series - Manual (Page 4)

NH033x-L and NH050x-L Series Power Modules: Data Sheet
5 Vdc Input; 1.2 Vdc to 3.3 Vdc Output; 10 A and 15 A March 2010
4 Lineage Power
General Specifications
Cleanliness Requirements
The open frame (no case or potting) power modules meet specification J-STD-001B. These requirements state
that any solder balls must be attached and their size should not compromise the minimum electrical spacing of the
power module.
The cleanliness designator of the open frame power module is C00 (per J specification).
Feature Specifications
Unless otherwise indicated, specifications apply over all operating input voltage, resistive load, and temperature
conditions. See Feature Descriptions and Design Considerations sections for further information.
* Total adjustment of trim and remote sense combined should not exceed 10% for V
O
≥ 2.5 V or 20% for V
O
< 2.5 V.
Parameter Min Typ Max Unit
Calculated MTBF (I
O
= 80% of I
O, max
; T
A
= 40 °C) 1,300,000 hours
Weight — — 14 (0.5) g (oz.)
Parameter Symbol Min Typ Max Unit
Remote On/Off Signal Interface
(V
I
= 4.5 V to 5.5 V; open collector pnp transistor or
equivalent; signal referenced to GND pin; see Figure 38
and Feature Descriptions section.):
Logic Low (ON/OFF pin open)—Module On:
I
on/off
= 0.0 µA
V
on/off
= 0.3 V
Logic High (V
on/off
> 2.8 V)—Module Off:
I
on/off
= 10 mA
V
on/off
= 5.5 V
Turn-on Time (I
O
= I
O, max
; V
O
within ±1% of steady
state; see Figures 25—32.)
V
on/off
I
on/off
V
on/off
I
on/off
—
–0.7
—
—
—
—
—
—
—
—
3.0
0.3
50
6.0
10
—
V
µA
V
mA
ms
Output Voltage Adjustment*
(See Feature Descriptions section.):
Output Voltage Remote-sense Range:
For V
O
≥ 2.5 V
For V
O
< 2.5 V
Output Voltage Set-point Adjustment Range (Trim):
For V
O
≥ 2.5 V
For V
O
< 2.5 V
—
—
V
TRIM
V
TRIM
—
—
90
100
—
—
—
—
10
20
110
120
% V
O, nom
% V
O, nom
% V
O, nom
% V
O, nom
Overtemperature Protection (shutdown)
(See Feature Descriptions section.)
T
Q32
115 120 — °C