Net Optics 10_100 to Triple-speed Port Aggregator - Manual (Page 12)

10/100 to Triple-speed Port Aggregator
8
Cabling Guidelines
Use straight-through cables to connect the Network ports to routers or NICs .
Use cross-over cables to connect the Network ports to switches and hubs . The
Network ports transmit on pins 3 & 6 and receive on pins 1 & 2 .
Note: ________________________________________________________________
Network Ports A and B automatically detect and match the speed and duplex
settings of the attached network devices.
______________________________________________________________________
Connecting to the Network
1 . Connect Network Port A to the appropriate network device following the
cabling guidelines above .
2 . Connect Network Port B to the appropriate network device following the
cabling guidelines above .
3 . Verify that the Tap Network Ports are cabled in-line between two devices .
Figure 5: Connecting to the Network
®
www.netoptics.com
1
2
Port Aggregator 1
Network Monitor
2 A B
10
100
1000
LINK
ACT
In-Line
To network switch or router To network switch or router