Asus P3-PE5 - Manual (Page 34)

2-18 Chapter 2: Basic installation
2.9.3 IDE hard disk drive installation
Set the IDE HDD as master device before connecting the IDE cable and
power plug. Refer to the HDD documentation for details.
To install an IDE hard disk drive:
1. Follow steps 1 to 2 of the previous section.
2. Connect the IDE cable (gray connector) to the IDE interface at the
back of the drive. Match the red stripe on the cable with Pin 1 on the
IDE interface.
3. Connect a power cable from the power supply unit to the power
connector at the back of the drive.
4. Follow steps 5 to 6 of the previous section to complete installation.
2.9.4 Uninstalling a hard disk drive
In the future, you may have to upgrade or replace a defective hard disk
drive.
To uninstall the hard disk drive:
1. Press the HDD screw lock (A),
then push the drive out from
the bay (B) until the drive
screws are released from the
screw rails.
2. Slightly lift the HDD, then
remove all plugs at the back of
the drive.
3. Install a new HDD following the
instructions in the previous
section.
A
B