Asus Terminator A7VT400 - Manual (Page 34)

2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8 2 - 1 8 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
5. Connect a power cable from
the power supply to the
power connector at the back
of the HDD. Use the cable with
the white connector labeled
P3.
6. Connect one end of the IDE
hard disk ribbon cable to the
IDE interface at the back of
the HDD, matching the red
stripe on the cable with Pin 1
on the IDE interface.
R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1 R e d s t r i p e t o P i n 1
I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e I D E r i b b o n c a b l e P o w e r c a b l e ( P 3 ) P o w e r c a b l e ( P 3 ) P o w e r c a b l e ( P 3 ) P o w e r c a b l e ( P 3 ) P o w e r c a b l e ( P 3 )
7. Connect the other end of the
IDE ribbon cable to the
primary IDE connector (blue
connector labeled PRI_IDE)
on the motherboard.
P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r P r i m a r y I D E c o n n e c t o r
( P R I _ I D E )
( P R I _ I D E ) ( P R I _ I D E ) ( P R I _ I D E ) ( P R I _ I D E )