Asus V3-M3N8200 - Manual (Page 37)

2-19 ASUS V2/V3-M3N8200
3. Connect the gray interface of the IDE ribbon cable to the IDE connector on
the drive.
4. If you install two IDE hard disk drives, connect the black interface of the IDE
ribbon cable to the IDE connector on the second (Slave) IDE hard disk drive.
5. Connect a 4-pin power plug from the power supply unit to the power
connector at the back of the drive(s).
• If you will install only one hard disk drive, make sure to configure your hard
disk drive as Master device before connecting the IDE cable and power
plug. Refer to the HDD documentation on how to set the drive as a Master
device.
• If you will install two IDE hard disk drives, configure the other device as
Slave.
2.9 Installing the card reader
An optional card reader module (see the figure below) is available with the system.
If you want to install the card reader into your system, follow the steps on the next
page.
The card reader is optional and users need to purchase separately.