Asus SL1200 - Manual (Page 112)

95
Chapter 9 - Configuring Firewall/NAT Settings
ASUS SL1200
9.7.2.2 Access NAT Pool Configuration Page – (Firewall ->
Policy List -> NAT Pool)
Log into Configuration Manager as administrator. Click Firewall -> Policy
List -> NAT Pool. The NAT Pool Configuration page displays as shown in
Figure 9.20.
When you open the NAT Pool Configuration page, a list of existing NAT
pools is also displayed at the bottom half of the configuration page such as
those shown in Figure 9.20.
Figure 9.20. NAT Pool Configuration Page
9.7.2.3 Add a NAT Pool
To add a NAT Pool
1. Open the NAT Pool Configuration page. See section 9.7.2.2 Access
NAT Pool Configuration Page.
2. Select
Add New Pool from the NAT Pool drop-down list.
3. Enter a pool name into the Name field.
4. Select a pool type from the Type drop-down list.
5. If
Static or Dynamic pool type is selected, enter the original IP
addresses (start IP Address, and end IP Address), and mapped IP
addresses (start NAT IP Address and end NAT IP Address). If Overload
pool type is selected, enter the NAT IP address. If you want to use the
IP address assigned for the WAN port as the NAT IP address, select the
Interface pool type.
6. Click on <
Add> to create the new NAT pool. The new NAT pool will
then be displayed in the NAT Pool List table.