Braun 5441 Flex Integral System - Manual (Page 12)

12
• Slide down the contact bow to connect the shaver
and to start the selected program.
If no program is selected, the default function
«clean» will be started.
• Do not interrupt a running program, as it leaves the
shaver wet and not fit for use. If interruption is need-
ed nonetheless, press the release button.
• After a program has finished, the corresponding light
will go out. If later on, and when in charging mode,
the charging light of the shaver comes on again. This
indicates that the shaver is being recharged to
maintain its full capacity. Prior to the next shave,
press the release button to release the shaver.
• When the «cartridge» light starts flashing, the
remaining fluid in the cartridge is sufficient for ap-
proximately 5 more cleaning cycles. After these
5 cycles, the cleaning performance will be reduced
and the car-tridge has to be replaced.
• When the «cartridge» light illuminates constantly, the
cleaning function is locked and a new cartridge has
to be installed. Only then, the next cleaning cycle
can be started.
• A cleaning cartridge should be sufficient for about
30 cleaning cycles. With daily use, the cleaning car-
tridge should be replaced approx. every 4 weeks.
• The hygienic cleaning solution cartridge contains
alcohol which, once opened, will naturally evaporate
slowly into the surrounding air. Each cartridge, if not
used daily, should be replaced after approximately
8 weeks.
Clean the housing from time to time with a damp cloth,
especially the opening where the shaver rests.
Accessories
Available at your dealer or Braun Service Centers:
Refill cartridge (double pack) CCR 2, (#5331)
Subject to change without notice.
select
5441
sele ct
5441
5485458_S.4-38.fm Seite 12 Dienstag, 22. Januar 2002 10:22 10