Asus GigaX2048 - Manual (Page 45)

33
GigaX2024/2048 L2 Managed Switch User Manual
You can remove the existed group by selecting the entry with the mouse, then
clicking on Remove. The Modify button updates the existed VACM Group
entries. Click OK to make the setting effective immediately. Click Reload to
refresh the settings to current value. To save configuration permanently, please
go to Save Configuration page, then click on Save.
Figure 41. VACM Group
4.6.5 VACM View
VACM(View-based Access Control Model) View is used to view the information
of SNMPV3 VACM Group.
View Name: enter the security group name. Multiple same names are
allowed.
View Type: enter the View Type that the View belongs. Included or Excluded
when View Subtree matches the Oid in the SNMPv3 message.
View Subtree: enter the View Subtree that the View belongs. The Subtree is
the Oid to match the Oid in the SNMPv3 message. The match is good when
the subtree is shorter than the Oid in the SNMPv3 message. Decimal value
is needed.
View Mask: enter the View Mask that the View belongs. Each bit in the
mask represents the digit between the dots of View Subtree from left side.
Bit ʻ0ʼ means ʻdonʼt careʼ. Even amount of difits(ex. Ff, ffc0) is preferred. Hex
value is needed.
Click on Add when you create a new VACM View entry by the above
information. Then you will see the new added entry shows in the view window.
You can remove the existed views by selecting the entry with the mouse, then
clicking on Remove. The Modify button updates the existed VACM View
entries. Click OK to make the setting effective immediately. Click Reload to
refresh the settings to current value. To save configuration permanently, please