Document Outline

• ASUSTeK COMPUTER INC. (Asia-Pacific)
  • Technical Support
  • ASUS COMPUTER INTERNATIONAL (America)
    • Technical Support
  • ASUS COMPUTER GmbH (Germany and Austria)
    • Technical Support
  • 1 Introduction
    • 1.1 L2 managed features
    • 1.2 Conventions used in this document
      • 1.2.1 Notations
      • 1.2.2 Typography
      • 1.2.3 Symbols
  • 2 Getting to know the GigaX
    • 2.1 Package contents
    • 2.2 Front Panel
    • 2.3 Rear Panel
    • 2.4 Technical specifications
  • 3 Quick start guide
    • 3.1 Part 1 — Installing the hardware
      • 3.1.1 Installing the switch on a flat surface
      • 3.1.2 Mounting the switch on a rack
    • 3.2 Part 2 — Setting up the switch
      • 3.2.1 Connect the console port
      • 3.2.2 Connect to the computers or a LAN
      • 3.2.3 Attach the RPS module
      • 3.2.4 Attach the power adapter
    • 3.3 Part 3 — Basic switch setting for management
      • 3.3.1 Setting up through the console port
      • 3.3.2 Setting up through the Web interface
  • 4 Management with the Web Interface
    • 4.1 Log into Web user interface
    • 4.2 Functional layout
      • 4.2.1 Menu navigation tips
      • 4.2.2 Commonly used buttons and icons
    • 4.3 System Pages
      • 4.3.1 Management
      • 4.3.2 IP Setup
      • 4.3.3 Administration
      • 4.3.4 Reboot
      • 4.3.5 Firmware Upgrade
    • 4.4 Physical Interface
    • 4.5 Bridge
      • Spanning Tree
      • 4.5.1 Link Aggregation
      • 4.5.2 Mirroring
      • 4.5.3 Static Multicast
      • 4.5.4 IGMP Snooping
      • 4.5.5 Traffic Control
      • 4.5.6 Dynamic Addresses
      • 4.5.7 Static Addresses
      • 4.5.8 Tagged VLAN
      • 4.5.9 Default Port VLAN and CoS
      • 4.5.10 DHCP Snooping
    • 4.6 SNMP
      • 4.6.1 Community Table
      • 4.6.2 Host Table
      • 4.6.3 Trap Setting
      • 4.6.4 VACM Group
      • 4.6.5 VACM View
      • 4.6.6 USM User
    • 4.7 Filters
      • 4.7.1 Filter Set
      • 4.7.2 Filter Attach
    • 4.8 Security
      • 4.8.1 Port Access Control
      • 4.8.2 Dial-In User
      • 4.8.3 RADIUS
      • 4.8.4 Port Security
        • 4.8.4.1 Port Configuration
        • 4.8.4.2 Port Status
        • 4.8.4.3 Secure MAC Addresses
    • 4.9 QoS
      • 4.9.1 Trust State
      • 4.9.2 Mapping
      • 4.9.3 Class Set
      • 4.9.4 Policy Set
      • 4.9.4 Policy Attach
      • 4.9.5 CoS
    • 4.10 Statistics Chart
      • 4.10.1 Traffic Comparison
      • 4.10.2 Error Group
      • 4.10.3 Historical Status
    • 4.11 Save Configuration
  • 5 Console Interface
    • 5.1 Power On Self Test
      • 5.1.1 Boot ROM Command Mode
      • 5.1.2 Boot ROM Commands
    • 5.2 Login and Logout
    • 5.3 CLI Commands
      • 5.3.1 System Commands
        • [System Name]
        • [System Contact]
        • [System Location]
        • [VLAN ID]
        • [IP Address]
        • [Network Mask]
        • [Default Gateway]
        • [Password Protection is] [Enabled/Disabled]
        • [New Password] [Verify Password]
        • [Reboot]
        • [Upload]
      • 5.3.2 Physical Interface Commands
        • [Admin] [Enable/Disable]
        • [Mode] [Auto/10M-Half/10M-Full/100M-Half/100M-Full/1G-Full]
        • [Flow Control] [Enable/Disable]
        • [Retrieve]
      • 5.3.3 Bridge Commands
        • [Spanning Tree is] [STP Enabled/ RSTP Enabled/ Disabled]
        • [Hello Time] [Forward Delay] [Max Age] [Bridge Priority]
        • Hello Time (1..10 seconds):[old Hello Time] <new Hello Time>
        • [Retrieve]
        • [Show Trunk]
        • [Create Trunk]
        • [Add/Remove Trunk]
        • [LACP Action]
        • [LACP System Priority]
        • [LACP Port Priority]
        • **For GigaX 2048
        • [Mirror] [Mirror 1/Mirror 2]
        • [Retrieve]
        • [Show Multicast Group]
        • [Set Multicast Group]
        • [Remove Multicast Group]
        • [Retrieve]
        • [Retrieve]
        • [Broadcast] [Enabled/Disabled]
        • [Multicast] [Enabled/Disabled]
        • [Limit]
        • [Retrieve]
        • [Aging Time]
        • [Query by Port]
        • [Query by VLAN ID]
        • [Query by MAC Address]
        • [MAC Address]
        • [VLAN ID]
        • [Port Selection]
        • [Discard] [none/source/destination/source & destination]
        • [Retrieve]
        • [Show VLAN]
        • [Name]
        • [VLAN ID]
        • [DHCP Snoop]
        • [Remove VLAN]
        • [Retrieve]
        • [PVID]
        • [Retrieve]
        • [Priority] [CoS Queue]
        • [Retrieve]
        • [DHCP Snooping is]
        • [Add/Remove Trusted Port]
        • [Retrieve]
      • 5.3.4 SNMP
        • [Community Name] [Set]
        • [Retrieve]
        • [Host IP Address] [Community]
        • [Retrieve]
        • [Trap Version] [v1/v2c]
        • [Destination]
        • [Community for Trap]
        • [Retrieve]
        • [Group Name]
        • [Read View Name]
        • [Write View Name]
        • [Notify View Name]
        • [Security Model]
        • [Security level]
        • [Retrieve]
        • [View Name]
        • [View Type]
        • [View Subtree]
        • [View Mask]
        • [Retrieve]
        • [Engine Id]
        • [Name]
        • [Auth Protocol]
        • [Auth Password]
        • [Priv Protocol]
        • [Priv Password]
        • [Retrieve]
      • 5.3.5 Filters Commands
        • [New]
        • [Remove]
        • [Edit]
        • [Rule Mode] [MAC Rule]
        • [Action] [Permit/Deny]
        • [Source MAC]
        • [Destination MAC]
        • [Add]
        • [Rule Mode] [IP Rule]
        • [Action] [Permit/Deny]
        • [Source IP] [Type/IP, Mask]
        • [Destination IP] [Type/IP, Mask]
        • [Source Port] [Type/Port]
        • [Destination Port] [Type/Port]
        • [Protocol] [ICMP/TCP/UDP/ANY]
        • [Add]
        • [Rule Mode] [MAC Rule]
        • [Action] [Permit/Deny]
        • [Source MAC]
        • [Destination MAC]
        • [Modify]
        • [Rule Mode] [IP Rule]
        • [Action] [Permit/Deny]
        • [Source IP] [Type/IP, Mask]
        • [Destination IP] [Type/IP, Mask]
        • [Source Port] [Type/Port]
        • [Destination Port] [Type/Port]
        • [Protocol] [ICMP/TCP/UDP/ANY]
        • [Modify]
        • [Rule Mode] [MAC Rule]
        • [Action] [Permit/Deny]
        • [Source MAC]
        • [Destination MAC]
        • [Delete]
        • [Rule Mode] [IP Rule]
        • [Action] [Permit/Deny]
        • [Source IP] [Type/IP, Mask]
        • [Destination IP] [Type/IP, Mask]
        • [Source Port] [Type/Port]
        • [Destination Port] [Type/Port]
        • [Protocol] [ICMP/TCP/UDP/ANY]
        • [Delete]
        • [Rule List]
        • [Filter ID]
        • [Ingress Port]
        • [Egress Port]
        • [Retrieve]
      • 5.3.6 Security Commands
        • [Reauthentication]
        • [Reauthentication Time]
        • [Authentication Method]
        • [Quiet Period]
        • [Retransmission Time]
        • [Max Reauthentication Attempts]
        • [Multi-host]
        • [Authentication Control]
        • [Retrieve]
        • Allows user to modify a user entry from the local database. It contains a user name, password and dynamic VLAN.
        • [Retrieve]
        • [Retrieve]
        • [Generate SSH key]
        • [Reset SSH key]
        • [Show Generating Status]
        • [Admin] [Enable/Disable]
        • CLI command: security portsecu admin <enable/disable> <port list/*>
        • [Violation Mode] [Protect/Restrict/Shutdown]
        • [Max MAC Addresses]
        • [Aging Time]
        • [Aging Type] [Absolute/Inactivity]
        • [Restart]
        • [Port Selection]
        • [Query]
        • [MAC Address]
        • [Port Selection]
        • [Add]
        • [Remove]
        • [Retrieve]
      • 5.3.7 QoS Commands
        • [State] [No/CoS/DSCP]
        • [CoSOverride] [Disable/Enable]
        • [CoS to DSCP]
        • [DSP to CoS]
        • [Class Name]
        • [Match][None/Filter/DSCP]
        • [Filter Set ID]
        • [DSCP][0/8/10/16/18/24/26/32/34/40/46/48/56]
        • [Add]
        • [Modify]
        • [Remove]
        • [Policy Name]
        • [Add]
        • [Remove]
        • [Edit]
        • [Class ID]
        • [DSCP]
        • [Traffic Rate]
        • [Traffic Burst Size]
        • [Exceed Action][None/Drop/DSCP]
        • [Exceed DSCP]
        • [Add]
        • [Modify]
        • [Remove]
        • [Policy ID]
        • [Attach/Detach]
        • [Retrieve]
        • [Scheduling Algorithm]
        • [CoS Queue ][Weight]
        • [Priority] [CoS Queue]
    • 5.4 Miscellaneous Commands
  • 6 IP Addresses, Network Masks, and Subnets
    • 6.1 IP Addresses
      • 6.1.1 Structure of an IP address
      • 6.1.2 Network classes
    • 6.2 Subnet masks
  • 7 Troubleshooting
    • 7.1 Diagnosing problems using IP utilities
      • 7.1.1 ping
      • 7.1.2 nslookup
    • 7.2 Replacing defective fans
      • Fan specifications
    • 7.3 Simple fixes
  • 8 Glossary
  • 9 Index