Asus Pundit-PE3 - Manual (Page 36)

2 - 2 0 2 - 2 0 2 - 2 0 2 - 2 0 2 - 2 0 C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n C h a p t e r 2 : B a s i c i n s t a l l a t i o n
2.9 Replacing the covers
After you install all the necessary components to the system, replace the
covers following the instructions in this section.
2.9.1 2.9.1 2.9.1 2.9.1 2.9.1 Replacing the front panel assembly Replacing the front panel assembly Replacing the front panel assembly Replacing the front panel assembly Replacing the front panel assembly
If you installed an optical drive, you must remove the optical drive bay
cover before you replace the front panel assembly.
To remove the optical drive bay cover:
1. Locate the optical drive bay
cover hook locks at the back of
the front panel assembly.
The photo on the right shows
the front panel assembly
without the optical drive bay
cover.
2. Press one lock inward (A), then
push the optical drive bay cover
from the outside of the front
panel assembly (B) to release.
A A A A A
B B B B B
To replace the front panel assembly:
1. Hook the hinge-like tabs to the
holes on the right side of the
chassis.
H i n g e - l i k e t a b s H i n g e - l i k e t a b s H i n g e - l i k e t a b s H i n g e - l i k e t a b s H i n g e - l i k e t a b s