Asus T2-P - Manual (Page 83)

83 ASUS Terminator 2 barebone system
13. System panel connector (8-1 pin PANEL)
This connector accommodates several system front panel functions.
P4P8T ®
P4P8T System Panel Connector
* Requires an ATX power supply.
PLED+
Ground
Power LED
PWR
ATX Power
Switch*
PLED- IDE_LED+ IDE_LED-
IDE_LED
PANEL
• Power LED Lead
This 2-pin connector connects to the system power LED. The LED
lights up when you turn on the system power, and blinks when the
system is in sleep mode.
• ATX Power Switch
This connector connects a switch that controls the system power.
Pressing the power switch turns the system between ON and SLEEP,
or ON and SOFT OFF, depending on the BIOS or OS settings.
Pressing the power switch while in the ON mode for more than 4
seconds turns the system OFF.
12. Modem connector (10-1 pin MDC)
This interface connects to the JP2 connector in the optional modem
module.
P4P8T ®
P4P8T MDC Connector
MDC
1
PHONE
AC_SYNC
AC_SDIN1
GND
MDC_BITCLK
GND
+3VSB
AC_RST#
AC_SDOUT