Asus M4A785-M - Manual (Page 37)

3. Serial ATA connectors (7-pin SATA1-6)
These connectors are for the Serial ATA signal cables for Serial ATA 3Gb/s hard disk
and optical disk drives. The Serial ATA 3Gb/s is backward compatible with Serial ATA
1.5Gb/s specification. The data transfer rate of the Serial ATA 3Gb/s is faster than the
standard parallel ATA with 133 MB/s (Ultra DMA133). If you install Serial ATA hard
disk drives, you can create RAID 0, RAID 1, and RAID 0+1 configurations through the
onboard SB710 chipset.
• Install the Windows ® XP Service Pack 1 or later versions before using Serial ATA.
• If you intend to create a Serial ATA RAID set using these connectors, set the type of
the SATA connectors in the BIOS to [RAID]. See section 2.3.4 SATA Configuration for
details.
• The motherboard does not provide a floppy disk drive connector. You could use a USB
floppy disk drive when installing Windows ® XP operating system on a hard disk drive
that includes a RAID/AHCI set.
• Due to Windows ® XP limitation, Windows ® XP may not recognize the USB floppy disk
drive.
• For more details on RAID/AHCI, refer to the RAID/AHCI Supplementary Guide included
in the folder named Manual in the support DVD.
ASUS M4A785-M 1-25