Asus P2-M2A690G - Manual (Page 79)

5-21 ASUS P2-M2A690G
Memory Configuration
Memory Configuration
Memory Setting: 333MHz-5.0-5-5-15-2T
Memclock Mode [Auto]
CAS Latency (CL) [Auto]
TRCD [Auto]
TRP [Auto]
TRAS [Auto]
Command Timing (2T mode) [ 2T]
MCT Timing Mode [Auto]
Bank Interleaving [Auto]
Enable Clock to ALL DIMMs [Disabled]
MemClk Tristate C3/ATLVID [Disabled]
DQS Signal Training Control [Enabled]
Memory Hole Remapping [Enabled]
Select the DRAM
Frequency programming
method. If Auto,
the DRAM speed will
be based on SPDs.
If Limit, the DRAM
spe will not exceed
the specified value.
If Manual, the DRAMs
specified will be
programmed regardless
Memclock Mode [Auto]
Allows you to select the DRAM Frequency programming method.
Configuration options: [Auto] [Limit] [Manual]
CAS Latency (CL) [Auto]
Allows you to select the CAS Latency (CL). Configuration options: [Auto]
[3.0] [4.0] [5.0] [6.0]
TRCD [Auto]
Allows you to select the TRCD. Configuration options: [Auto] [3 CLK] [4
CLK] [5 CLK] [6 CLK]
TRP [Auto]
Allows you to select the TRP. Configuration options: [Auto] [3 CLK] [4 CLK]
[5 CLK] [6 CLK]
TRAS [Auto]
Allows you to select the TRAS. Configuration options: [Auto] [5 CLK] [6
CLK] [7 CLK] [8 CLK] [9 CLK] [10 CLK] [11 CLK] [12 CLK]
Command Timing (2T mode) [Auto]
Allows you to select the command timing. Configuration options: [Auto] [
1T] [ 2T]
MCT Timing Mode [Auto]
Allows you to select the MCT timing mode. Configuration options: [Auto]
[Manual]
Bank Interleaving [Auto]
Allows you to enable or disable the bank memory interleaving. If set to
AUTO, the memory will be checked which executes 64 or 128-bits mode.
Configuration options: [Disabled] [Auto]
Enable Clock to All DIMMs [Disabled]
Allows you to enable or disable unused clocks to all DIMMs even memory
slots are not populated. Configuration options: [Disabled] [Enabled]