Asus T4-M3N8200 - Manual (Page 34)

2-16 Chapter 2: Basic installation
2.9 Installing a Serial ATA disk drive
The system supports one Serial ATA hard disk drive.
To install a Serial ATA hard disk drive:
1. Connect the SATA power cable to
the plug of the power supply unit.
2. Connect the SATA signal cable and
the power plugs to the connectors
at the back of the drive.
3. Locate the HDD tray.
4. Insert a hard disk drive (with the
HDD PCB facing the top of the
chassis) to the tray, then secure it
with four screws.
5. Connect the SATA signal cable to the
SATA connector on the motherboard,
and tighten all the cables with the
plastic coils.
1
2
4
4
4
4
4