Asus Adaptec 2025 ZCR - Manual (Page 102)

C-7
Adaptec Flash Utility (AFU)
Examples
In the following example, the AFU saves flash contents from
controller 0 to a UFI file in the current default drive and directory:
A:\> AFU SAVE /C 0
In the following example, the AFU saves flash contents from
Controller 1 to a UFI file in
C:\UFI_FILES .
A:\> AFU SAVE /C 1 /D C:\UFI_FILES
UPDATE
The UPDATE command updates a controller’s flash components
from the flash image data in a UFI file. You can use the UPDATE
command to update a single controller’s flash components or to
update multiple controllers on your computer.
You must restart the computer following an UPDATE command.
Command Syntax
The command syntax for the UPDATE command is as follows:
AFU UPDATE [/C<Controller ID>] [/D <UFI File Path>]
Command Switches
For details on the /C and /D switches, see the SAVE command on
page C-6 .
Example
The following example shows a typical system response after an
update has been performed.
A:\> AFU UPDATE /C 0
Adaptec Flash Utility V4.0-0 B5749
(c)Adaptec Inc. 1999–2002. All Rights Reserved.
Updating Controller 0 (Adaptec 2410)
Reading flash image file (Build 5749)
AFU is about to update firmware on controllers Adaptec 2410
***PLEASE DO NOT REBOOT THE SYSTEM DURING THE UPDATE***
This might take a few minutes.
Writing Adaptec 2410 (4MB) Flash Image to controller 0...OK.
Verifying...OK
Please restart the computer to allow firmware changes to take
effect.