Asus E500-PV - Manual (Page 34)

34 ASUS CUV4X User’s Manual
Connectors
3. H/W SETUP
3. HARDWARE SETUP
10) Floppy Disk Drive Connector (34-1 pin FLOPPY)
This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).
NOTE: Orient the red markings on
the floppy ribbon cable to
PIN 1
CUV4X Floppy Disk Drive Connector
PIN 1
CUV4X
11) Chassis Intrusion Lead (2 pin CHASSIS)
This requires an external detection mechanism such as a chassis intrusion moni-
tor/sensor or microswitch. The sensor is triggered when a high level signal is
sent to the Chassis Signal lead, which occurs when a panel switch or light detec-
tor is triggered. If the chassis intrusion lead is not used, a jumper cap must be
placed over the pins to close the circuit.
CUV4X
CUV4X Chassis Open Alarm Lead
CHASSIS