AIPTEK PocketCinema V150W - Manual (Page 2)

User’s Manual
Page 2
EN
13. Do not drop or disassemble the product otherwise the warranty voids. Opening or
removing covers may expose you to dangerous voltage or other hazards. Refer all
servicing to an authorized service center.
14. Use only the accessories supplied by the manufacturer.
15. Both product and user’s manual are subject to further improvement or supplement
without further notice.
Care and Safety Information for Pico Projectors
1. Avoid facing directly into the projector’s lens.
2. During the operation, this product may heat
lightly, which is normal.
3. The device should not be used in a very
dusty environment. Dust particles and other
foreign objects may damage the unit.
4. Do not expose the device to extreme
vibrations. It may damage the internal
components.
5. Use the enclosed power adapter (see technical data):
Check whether the mains voltage of the power supply matches the mains voltage
available at the setup location. This equipment complies with the voltage type
specified on the unit.
Notice for Long-time Projection
The built-in battery supports approximately 120 mins of projection. For long time
projection, you are recommended to use AC adapter.
When the battery is too weak to stay in operation, the low battery capacity icon (
)
will flash. You need to charge the product while the icon showed.
It’s normal that the projector will feel warm with continuous use due to its high
performance. If the projector runs for a long time and over-heated, the
High-Temperature icon (
) will appear on the screen. The system will automatically
enter the standby mode.
Avoid Hearing Damage:
Listening at high volume for a
long period of time could cause
damage to your ears.