AIPTEK PocketCinema V150W - Manual (Page 7)

User’s Manual
Page 7
EN
Remote Control
Installing the Remote Control Battery
1. Remove the battery holder by holding down the side release
firmly and pulling out the battery holder.
2. Insert a CR2025 coin cell battery and align the polarity
correctly according to the marking in the battery holder.
Note: When you use the remote control for the first time,
there is a plastic sheet between the battery and its
contact. Remove the sheet before use.
3. Insert the battery holder.
Warning:
Improper use of the battery may cause overheating, explosion or ignition, which can
result in an injury or a fire. Battery leakage may damage the remote controller.
Do not expose the remote controller unit to direct sunlight.
Do not expose the battery to fire or water.
Immediately replace the exhausted battery.
Take out battery when the remote is not in use for a long time.
Left / Previous
Exit (one menu step back)
Right / Next
Power
Lens Mode
Volume Down
Menu
Scene Mode
Source
Brightness
Down
OK
Volume Up
Up