2 mounting the nyx-7 to a goggle kit, 3 mounting the nyx-7 to a helmet – Armasight NSGNYX7001QGDI1 Nyx7 GEN 2+ QS Night Vision Goggles User Manual
Page 18
18
3.1.2 MOUNTING THE NYX-7 TO A GOGGLE KIT
Mount the Nyx-7 to the optional goggle kit as follows:
1. Put on the goggle kit. Adjust the goggle kit strap pads until the goggles fit securely around your
head. Remove the goggle kit.
2. Loosen the screw (A). While pushing down on the button (B), insert the Nyx-7 rail into the guide (C) of
the goggle kit bracket. Tighten the screw (A).
3. Put on the goggle kit, now mounted with the Nyx-7.
4. To adjust the equipment for greater comfort, loosen the screw (A) and move the unit along the guide (C).
5. The goggle kit has a flip-up mechanism. Push the button (D) of the goggle kit bracket and lift the unit
up until it reaches its topmost position.
6. Push the same button (D) to lower the unit into the correct viewing position.
7. Push the button (E) and move the unit along the slide-rail (F) until the most comfortable position is
reached.
8. To remove the Nyx-7 from the goggle kit, loosen the screw (A), push the button (B), and slide the unit
out of the bracket guide (C).
The Nyx-7 contains Flip-up Shutoff System. This system turns the unit off when the Nyx-7 is in the up-
right position on the flip-up head mount. Turn the Nyx-7 on for continuation of the operation when
when the device is back into viewing position.
A
FIGURE 3-2. MOUNTING NYX-7 TO A GOGGLE KIT
B
C
D
E
F
3.1.3 MOUNTING THE NYX-7 TO A HELMET
An optional flip-up helmet mount can be used to attach the Nyx-7 to a helmet. The helmet mount fits
the Nyx-7 securely onto the helmet via a rugged strapping device and grooved hooks. With the helmet
mount, the Nyx-7 can be positioned directly in front of the user’s eyes, or flipped backwards, out of the
field of view.
Mount the Nyx-7 to a helmet as follows:
1. Attach the mount to the helmet as shown in Figure 3-3.
2. Adjust and tighten the straps (A).
3. Loosen the screw (B). With the button (C) pushed down, insert the Nyx-7 rail into the guide (D) of the
helmet mount bracket. Tighten the screw (B).
4. Put on the helmet with the Nyx-7 attached.