Armasight NSGNYX7001QGDI1 Nyx7 GEN 2+ QS Night Vision Goggles - Manual (Page 19)

19
5. Push the button (F) and move the unit along the slide-rail (G) until the most comfortable position is
reached.
6. To adjust the unit for comfort, loosen the screw (B) and move the unit along the guide (D).
7. Turn the lever (I) and move the unit along vertical slide-rail until the most comfortable vertical posi-
tion is reached.
8. To remove the Nyx-7 and turn it around, push the button (E) and lift the unit up until it reaches the
topmost position.
9. Push the same button (E) to lower the Nyx-7 into the proper viewing position.
10. To remove the Nyx-7 from the helmet mount, loosen the screw (B), push down on the button (C),
and slide the unit out of the guide (D).
11. To remove the flip-up mechanism from the helmet mount, loosen the lever (I), pull the knob out (H),
and slide the flip-up mechanism out of the vertical rail.
The Nyx-7 contains Flip-up Shutoff System. This system turns the unit off when the Nyx-7 is in the up-
right position on the flip-up helmet mount. Turn the Nyx-7 on for continuation of the operation when
when the device is back into viewing position.
C
D
E
G
B
I
FIGURE 3-3. MOUNTING THE NYX-7 TO A HELMET
F
A
H
3.1.4 MOUNTING ACCESSORY LENSES TO THE NYX-7
To mount the 3X afocal lens to the device, screw it into the threading of the standard 1X objective lens
on the Nyx-7.
To mount the 5X or 8X lens, unscrew the existing 1X objective lens of the Nyx-7 and screw in the 5X or
8X lens in its place.
The Nyx-7 configured with an 8X lens can be installed on a tripod. To mount the unit on a tripod, use
the 1/4’’ threaded socket (E) on the housing of the 8X lens.
FIGURE 3-4. MOUNTING A 5X LENS TO THE NYX-7