AVSL 171.802 UH5 - Manual (Page 2)

171.802UK User Manual
Caution: Please read this manual carefully before operating
Damage caused by misuse is not covered by the warranty
Introduction
Thank you for choosing the QTX Sound UH5 wireless system. This professional wireless set provides a high quality
microphone with UHF radio system for freedom of movement without loss of audio quality. Please read this manual
before using this equipment in order to avoid damage through incorrect operation and to get the best performance from
your purchase.
Contents:
Please take care when unpacking this product. Inspect for any damage and ensure you have the following components…
 UHF wireless receiver
 Mains power adapter
 6.3mm mono jack lead
 2 x AA batteries
 Handheld UHF microphone transmitter
Warning
To prevent the risk of fire or electric shock, do not expose any of the components to rain or moisture.
If liquids are spilled on any component, stop using immediately, allow unit to dry out and have checked by qualified
personnel before further use.
Avoid impact or heavy vibration to any of the components, dropping the microphone can cause capsule failure.
No user serviceable parts inside transmitter or receiver - refer servicing to qualified service personnel.
Safety
 Ensure that the correct adapter is used with adequate current rating and that the mains voltage is as stated on the
adapter.
 Avoid ingress of water or particles into the transmitter or receiver
 Use alkaline or NiMH batteries in the transmitter and remove if unused for long periods.
 Observe the correct polarity when replacing batteries
Placement
 Keep all components out of direct sunlight and away from heat sources.
 Do not place heavy objects on top of the receiver or transmitter
 Keep the transmitter and receiver away from damp or dusty environments.
Cleaning
 Use a soft cloth with a neutral detergent to clean the body of the microphone/transmitter and receiver.
 Lightly damp sterile wipes may be used on the microphone grille for hygiene purposes
 To avoid damage, do not use solvents to clean the components