AVSL 171.802 UH5 - Manual (Page 4)

171.802UK User Manual
If the wireless system is not to be used for more than a few seconds, it is preferable to slide the transmitter switch to the
“OFF” position, which mutes and deactivates the radio signal and powers down the transmitter. Be sure to turn down the
volume of the mixer or amplifier and then switch off the receiver. Unplug signal leads from the receiver and mixer or
amplifier when moving or packing away.
If the system is not to be used for long periods of time, remove the batteries from the transmitter and unplug the power
adapter from the receiver and the mains outlet. Retracting the antennae can also help avoid damage when the system is
not in use.
Specifications
Power supply - receiver 12-18Vdc, 350mA adaptor (included)
Power supply - transmitter 3Vdc (2 x AA batteries included)
Current consumption : Handheld <100mA
Carrier frequency 864.99MHz
Maximum range 50.0m
Sensitivity -105dB @ ±12dB
Signal to noise ratio >105dB
THD <0.5% @ 1KHz
Output connection XLRF or 6.3mm jack
Frequency response 50Hz - 18KHz (±1dB)
Dimensions - handheld transmitter 265 x 46mmØ
Weight - handheld transmitter 174g (no battery)
Dimensions - receiver 209 x 150 x 42mm
Weight - receiver 390g
Troubleshooting
“POWER” LED does not light on receiver
Ensure power adapter is connected to mains and working properly
Ensure receiver is switched on
“POWER” LED is lit but no “SIGNAL” LED
Ensure transmitter is switched on
Check that transmitter is not out of reception range
Check that transmitter battery is good / charged
LEDs are lit but no sound from
microphone
Check if transmitter switch is in “MUTE” position
Make sure receiver is connected to mixer / amplifier
Make sure that amplifier / mixer channel volume is turned up
Ensure transmitter has a good / charged battery
Check if there is another nearby transmitter with the same frequency
Turn down VOLUME on receiver
Reduce Gain on mixer / amplifier
Ensure that XLR output is not fed to a Line input
Turn up VOLUME on receiver
Increase Gain on mixer / amplifier
Ensure that Jack output is not fed to a Mic input
Check transmitter battery
Disposal: The “Crossed Wheelie Bin” symbol on the product means that the product is classed as Electrical or
Electronic equipment and should not be disposed with other household or commercial waste at the end of its useful life.
The goods must be disposed of according to your local council guidelines.
1622
Errors and omissions excepted.
Copyright© 2013. AVSL Group Ltd.