C2G 39979 PCLinq2 Hi-Speed USB Bridge-Network Cable - Manual

PCLinq2 Hi-Speed USB Bridge-Network Cable
Quick Network Setup Guide
For Windows 98/ME/2000/XP
Congratulations!
Congratulations for installing the PCLinq2 Hi-Speed USB Bridge-Network Cable.
This Quick Network Setup guide is only for explaining the network device mode
installation of the cable. For information on how to use the data bridge device
mode, please refer to the PCLinq2 Data Bridge User’s Manual.
Driver Installation
1. Run the Hi-Speed USB Bridge-Network Cable Setup program.
2. When Setup is complete, plug in the USB Bridge-Network cable to the USB
port of your computer.
3. Depending on the default device mode of your cable or the last saved device
mode, the New Hardware Wizard will detect the “Hi-Speed USB-USB Network
Adapter” or “Hi-Speed USB Bridge Cable” device and will prompt you to install
the software. Click “Install the software automatically” and Next button to
continue.
4. Windows will detect that the software you are installing has not yet passed
Windows Logo testing. Click “Continue Anyway”.
5. Wait until the New Hardware Wizard finishes installing the software. Click the
Finish button if installation is complete.
6. To install the drivers for the other device, you need first to change the device
mode using the PCLinq2 utility program. Refer to the next section.