C2G 29596 WIRELESS USB TO VGA AND AUDIO KIT - Manual (Page 36)

35
Figure: Cable Association
C ABLE A SSOCIATION P ROCEDURE
Cable association steps. Examples/Figures shown are used with the association of the TruLink Wireless
VGA Device Adapter (part #29573) and TruLink Wireless Audio Device Adapter (Part # 29595) when used
with the TruLink Wireless USB Host Adapter (part # 29578). This process will vary by manufacturer of
your Wireless USB host adapter.
1. Make sure that the Wireless USB host adapter utility is running. Check your Windows tray for the
Wireless USB Manager icon (Figure: Wireless USB Manager).
2. Make sure the WIRELESS/WIRED switch is in the WIRELESS position on the Wireless VGA Device
Adapter.
3. Plug in the power adapter for your TruLink Wireless VGA Device Adapter.
4. Connect the USB cable between an available USB port on your computer and your Wireless VGA
Device Adapter.
5. Complete cable association by pressing the “Accept Association” button when prompted (Figure: Cable
Association).
6. Remove the USB cable from your Wireless USB Device Adapter and computer.
7. Repeat steps 1, 3-6 for the TruLink Wireless Audio Device Adapter because no switch is present on
the unit from step 2.
A PPENDIX