C2G 26630 10_100Base-TX to 100Base-TX Media Converter - Manual (Page 14)

10/100Base-TX to 100Base-FX Mini Converter
- 10 -
2. Affix the four (4) self-adhesive rubber pads to the
underside of the Converter.
3. Apply AC power to the Converter. (The green
PWR LED should be lit).
4. Connect cables from the network partner devices
to the ports on the front panel. (The green LNK
LED on the front panel associated with the port
should be lit).
Warning
Please exercise caution when using power tools. Also, install
this unit away from damp or wet locations, or in close
proximity to very hot surfaces. These types of environments
can have a detrimental effect on the converter and cables.
An ideal location is a lightly cooled place such as a typical
equipment room. Because invisible laser radiation may be
emitted from the aperture of the port when no cable is
connected, avoid exposure to laser radiation and do not stare
into open apertures.