Acer X1270 User Manual
Page 52
42
En
gl
ish
To Change the Lamp
1
Turn off the projector by pressing the power button.
2
Allow the projector at least 30 mins to cool down.
3
Disconnect the power cord.
4
Open the screw cover on the right side of the projector. (Illustration #1)
5
Remove the screw on the right side of the projector. (Illustration #2)
6
Push and slide the top cover (Illustration #3) and then open the top cover.
(Illustration #4)
7
Remove the two screws that secure the lamp module (Illustration #5) and
pull up the lamp bar. (Illustration #6)
8
Pull out the lamp module by force. (Illustration #7)
To replace the lamp module, reverse the previous step.
Warning: To reduce the risk of personal injury, do not drop the
lamp module or touch the lamp bulb. The bulb may shatter and
cause injury if it is dropped.