Acer Altos R700 - Manual (Page 102)

5 Solving Problems 92
persists, try a different cable.
• Make sure the hub port is configured for the same duplex mode as
the network controller.
• Check with your LAN administrator about the correct networking
software that needs to be installed.
• If you are directly connecting two servers (no hub), you will need a
crossover cable (see your hub documentation for more
information on crossover cables).
• Check the network controller LEDs that are visible through an
opening at the system back panel.
AR700SB-e.book Page 92 Monday, September 30, 2002 9:09 AM