Bell & Gossett 6 71 075 111A Autocirc Instant Hot Water Pump Model ecocirc 23 5 ACT - Manual (Page 7)

7
There shall be no other warranty or obligation, expressed or implied, oral or
statutory. B&G, its agents, or employees shall in no event be liable for injury to
any person, or for any claim for damage, however arising.É
B&G shall not be liable for any incidental or consequential damages for breach
of any express or implied warranty, breach of contract, negligence, strict
liability, or any other legal theory related to this product. All consequential
expensesÉincluding loss of use, damages, or contingent liabilities arising out of
any alleged deficiencies of the Autocirc or any ancillary item packaged with the
Autocirc are specifically excluded from this warranty.É
This warranty is the sole and exclusive remedy for defects in materials and
workmanship. All implied warranties of fitness and merchantability are hereby
expressly excluded. There are no warranties that extend beyond the description
on the face hereof.É
WARNING: - Excessive System Pressure Hazard - The maximum working pressure of the
pump is listed on the nameplate - Do Not Exceed This Pressure. Failure to follow these
instructions could result in serious personal injury, death and/or property damage.
Safety Requirements
Mechanical Safety
WARNING: - Electrical Grounding Hazard - Adequate electrical grounding is required for
the safe operation of B&G Pumps. Ground the pump back to the service using a copper
conductor at least the size of the circuit connectors supplying the pump. Connect the ground
wire to the ground terminal in the wiring compartment. Failure to follow these instructions
could result in serious personal injury, death and/or property damage.
WARNING: - Risk of Electric Shock - Do not install this pump in swimming pool or marine
areas. Failure to follow these instructions could result in serious personal injury, death and/or
property damage.
WARNING: - Excessive Pressure Hazard Volumetric Expansion - The heating of water and
other fluids causes volumetric expansion. The associated forces may cause failure of system
components and the release of high temperature fluids. This can be prevented by installing
properly sized and located compression tanks and pressure relief valves. Failure to follow
these instructions could result in serious personal injury, death and/or property damage.
WARNING: - Extreme Temperature Hazard - If the pump, motor or piping are operating at
extremely high or low temperature, guarding or insulation is required. Failure to follow these
instructions could result in serious personal injury, death and/or property damage.
WARNING: - Electrical Shock Hazard - Electrical connections are to be made by a qualified
electrician in accordance with all applicable codes, ordinances and good practices. Failure
to follow these instructions could result in serious personal injury, death and/or property
damage.
Thermal Safety
Electrical Safety
WARNING: - Risk of Electric Shock - If this pump is supplied with a grounding conductor
and grounding-type attachment plug, to reduce the risk of electric shock, be certain that it is
connected only to a properly grounded, grounding-type receptacle.