YSI Data Scout - Manual (Page 26)

3.5.3 DATA TEST TAB
The Data tab allows selection of the parameters to be logged (Figure 3.43). The available parameters are: Level (the current level
measurement in the configured units), Sensor Temperature (the temperature of the level sensor itself), and Voltage (the current
battery voltage). Level Scouts with 4 MB of memory incorporate one additional measurement, a high precision temperature sensor
located on the circuit board. If the attached transducer is identified as a 4 MB version by the model number (models AS4. AT4, VS4,
and VT4), an additional check box will become available to enable logging of this parameter.
Figure 3.43
3.5.4 CONTROL TEST TAB
The ‘Control’ tab allows the user to start, end, or modify a test. To start a test, select the desired test in the upper left of the window
and check “Enable Test Selected Above” (Figure 3.44).
Figure 3.44
To end a test, click the End Currently Active Test button (Figure 3.45). The “Currently Active Test #” is listed directly above this
button.
Figure 3.45
Click the Alarms and Broadcasts button (Figure 3.46) for quick access to the Alarms and Broadcasts screen detailed in Section 3.4.2.
Figure 3.46
YSI Incorporated Data Scout 26