Extron Electronics BUC 102 - Manual (Page 9)

BUC 102 • Installation and Operation
Furniture/Projector mounting
Use the MBU 123 optional mounting kit (furniture,
part #70-212-01, or the PMK 100 projector pole mount kit, part
#70-217-01) to mount the BUC 102, as follows.
Furniture mounting
1. Remove the rubber feet if they were previously installed.
2. Attach the mounting
bracket to the BUC
102, as shown here.
a. Remove the
two machine
screws from
one side of the
unit. Save these
screws for
future use.
b. After lining up
a bracket with
the holes, attach
the bracket
using the longer machine screws provided.
c. Repeat this step to attach the other bracket.
3. Attach the BUC 102 to the furniture.
a. Hold the unit against the underside of the table or
other furniture, and mark the locations for four screws
(two screws per bracket) on the mounting surface.
b. At each mark, drill a 3/32" (2 mm) diameter pilot hole
approximately 1/4" (6 mm) deep in the mounting
surface.
c. Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until just less
than 1/4" (6 mm) of the screw protrudes.
d. Align the bracket slots with the wood screws and place
the unit against the mounting surface.
e. Slide the unit either forward or backward until the
screws are in contact with the edge of the bracket slots.
Then, tighten each screw to secure the unit in place.
L
R
5