Removing and replacing the system, To remove the system – Extron Electronics Cable Retraction System User Guide User Manual
Page 31
25
Cable Retraction System • Maintenance and Adjustments
25
Removing and Replacing the System
To Remove the System:
DANGER: Ensure that AC power is disconnected before servicing the system.
1.
Remove both ends of all retractor cables from connected devices.
NOTE: Drop-in installations require removal of the enclosure and retraction
system at the same time.
2.
If necessary, loosen the locking screw on all retractors. If the system is mounted
vertically, proceed to step
6.
Loosen locking
screw (1 ea).
Figure 25.
Loosen Locking Screws
3.
Hold or otherwise support the cable retraction system near the horizontal bracket.
4.
Remove the nut and slide the bolt from the horizontal mounting bracket.
CAUTION: All cable retractors attached to the horizontal mounting bracket will
drop when the bolt is removed.
Support the
retractor system.
Remove bolt.
4
3
Figure 26.
Remove Horizontal Mounting Bolt