Xoro HTL 2231D - Manual (Page 69)

HTL 2231D 17
Engl
ish
Connection
Power connection
Connect the power cable (small connector) to the DC 12 V IN input of the TV
set. Connect the power cable of AC/DC power adapter with the wall mounted
power outlet.
On the front side you can see a red LED light. The TV set is now in Stand-By
mode. By pressing the POWER button on the remote control or on the top side
of the device the red LED changes to a green light.
Antenna
The TV set has an analogue and a digital TV Tuner inside. For receiving analogue TV
signals please connect the antenna cable with the RF connector on the TV set and with
the VHF/UHF roof antenna or with a CATV antenna plug.
For receiving digital terrestrial TV signals please connect the TV set with the RF plug
and also with the roof antenna. If no roof antenna is available, please use indoor aerial.
For activating the analogue TV Tuner, please switch with the SOURCE button and
choose in the popup window „ATV“ or “DTV“ for digital terrestrial TV.
Note:
For getting the best DVB-T reception please uses the roof antenna. If not possible, than you can
connect the TV set with an active indoor aerial.
SCART Input
Audio– and Video signals from a VCR or a setop box can be
transmitted by SCART. Please connect a SCART cable with the
SCART input on the TV set and with the SCART output on the VCR or
setop box.
Press the SOURCE button and choose „SCART“ in the popup window
and the SCART interface is activated.
HDMI
If you want connect a multimedia device with HDMI like a game console „PS3“ or
a Setop box with the TV set, you can establish a HDMI connection. Please
connect the HDMI cable on the HDMI interface on the TV set and the HDMI
output of the multimedia device.
You can also connect the TV set to you personal computer by HDMI cable. Here
you can uses the Full-HD resolution (1920 x 1080).
Please press the SOURCE button and choose „HDMI“ in the popup window and the HDMI input is
active.