Extron Electronics DTP HDMI 301 User Guide - Manual (Page 14)

TP cable termination
Figure 7 details the recommended termination of TP cables with RJ-45 connectors in
accordance with either the TIA/EIA T 568A or the TIA/EIA T 568B wiring standard.
5
Pin
1
2
3
6
7
8
4
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Blue
Wire color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
TIA/EIA T
568 A
TIA/EIA T
568 B
Blue
Side
12345678
Insert
Twisted
Pair Wires
Pins:
RJ-45
Connector
Figure 7. TP Cable Termination
NOTES: • RJ-45 termination with CAT 5e, CAT 6, or CAT 6a cable must comply with
the TIA/EIA T 568A or TIA/EIA T 568B wiring standard for all connections.
• Terminate both ends of both cables identically, in accordance with either
TIA/EIA T 568A or TIA/EIA T 568B.
• Do not use Extron UTP23SF-4 Enhanced Skew-Free™ AV UTP cable or
STP201 cable to link the transmitter and receiver. The DTP DVI 301 Tx/Rx
does not work properly with these cables.
• Only one cable, DTP, is necessary. The Analog Audio cable carries an
additional audio signal that is not required for system operation.
• Connect transmitter DTP Out to receiver DTP In.
Connect transmitter Analog Audio Out to receiver Analog Audio In.
• If necessary, check the DTP Out to DTP In cable connection as follows:
1 . Plug a cable into the DTP port on the powered unit.
2 . Connect the opposite end of the cable into the DTP port on the
unpowered unit.
If the DTP Link LED and the Power LED on the unpowered unit are lit, the
connection is correct.
DTP HDMI 301 • Installation and Operation 8