Extron Electronics DTP HDMI 301 User Guide - Manual (Page 16)

Power supply wiring
NOTES: • Only one power supply is required. A single power supply connected to
either unit in the pair powers both units.
• A power supply is included with each transmitter.
Figure 11 shows how to wire the connector. Use the supplied tie-wrap to strap the power
cord to the extended tail of the connector.
Power Supply
Output Cord
Captive Screw
Connector
SECTION A–A
Ridges
Smooth
A A
Tie Wrap
3 5
Figure 11. Power Connector Wiring
CAUTIONS: • This product is intended to be supplied by a Listed Power Unit marked
“Class 2” or “LPS,” rated 12 VDC, 1.0 A minimum. Always use a power
supply supplied by or specified by Extron. Use of an unauthorized power
supply voids all regulatory compliance certification and may cause
damage to the supply and the end product.
• Unless otherwise stated, the AC/DC adapters are not suitable for use in
air handling spaces or in wall cavities.
• The installation must always be in accordance with the applicable
provisions of National Electrical Code ANSI/NFPA 70, article 75 and the
Canadian Electrical Code part 1, section 16. The power supply shall not
be permanently fixed to a building structure or similar structure.
• Power supply voltage polarity is critical. Incorrect voltage polarity can
damage the power supply and the unit. The ridges on the side of the
cord (see figure 11) identify the power cord negative lead.
To verify the polarity before connection, plug in the power supply with no load and check
the output with a voltmeter.
WARNING : The two power cord wires must be kept separate while the power supply is
plugged in. Remove power before wiring.
CAUTION: The length of the exposed (stripped) copper wires is important. The ideal
length is 3/16 inch (5 mm). See the NOTE on page 6 for details.
NOTE: Do not tin the power supply leads before installing them in the connector.
Tinned wires are not as secure in the connector and could be pulled out.
DTP HDMI 301 • Installation and Operation 10