Extron Electronics DSC 301 HD User Guide - Manual (Page 36)

Command ASCII Command
(host to scaler)
Response
(scaler to host)
Additional Description
Input presets
Recall preset 2*X2). 2RprX2)] Recall input preset X2) for selected
input.
Save preset 2*X2), 2SprX2)] Save input preset X2) for selected
input.
Delete/clear preset E X2*X2)PRST} PrstX2*X2)] Clears input preset X2) , and sets input
preset X2) name to [unassigned].
Input preset name
Write name E 2*X2),X1#PNAM} Pnam2*X2),X1#] Set the input preset X2) to X1# .
Read name E 2*X2)PNAM} X1#] Read the name for input preset X2) .
NOTE: Unassigned presets = “ [unassigned]”. To restore a default user preset name, enter a single space character for X1# . Valid only
for previously saved presets.
User Presets Input Presets
Color H/V Image
Position
Color H/V Image
Position
Input Type H Start
Tint H/V Image
Size
Tint H/V Image
Size
Audio Gain/
Attenuation V Start
Contrast Preset Name Contrast Preset Name Film Mode H Active
Brightness Brightness Total Pixels V Active
Detail Detail Phase
Figure 18. Values Saved in User and Input Presets
Auto memories (per input)
Enable E X! *1AMEM} Amem X! *1 ] Set auto memory on. Previous settings
for incoming signal are auto recalled.
Disable E X! *0AMEM} Amem X! *0 ] Set auto memory off. Manual recall
of input presets needed to configure
input.
View setting E X! AMEM} X(] View current auto memory for input
X! .
NOTE: X! = Input selection: 1 to 3
X( = Enable or disable: 0 = Off or disable, 1 = On or enable
X1# = Text label or preset name, up to 16 characters
X2) = Input presets, 1-128 (global)
DSC 301 HD • SIS Communication and Control 30