Furniture mounting the switcher – Extron Electronics MAV 44_48_84_88 Series User Guide User Manual
Page 19
2-3
MAV 44 / 48 / 84 / 88 Matrix Switchers • Installation
#8 Screw (4 Plcs)
Each Side
Mounting Screws (2 Plcs)
Each Side
or
100-240V 0.
3A
IN
OUT
SYNC
RS 232
3
4
5
6
7
8
1
2
1
2
3
4
5
6
7
8
INPUTS
OUTPUTS
INPUTS
MA
V 88 A
V
OUTPUTS
L
R
7
L
R
8
L
R
5
L
R
6
L
R
3
L
R
4
L
R
1
L
R
2
L
R
7
L
R
8
L
R
5
L
R
6
L
R
3
L
R
4
L
R
1
L
R
2
50-60Hz
Rack-mount
Bracket
(Included)
Table/
Wall-mount
Bracket (Optional)
Drill pilot holes
3/32” (2 mm) dia.,
1/4” (6 mm) deep.
Figure 2-1 — Mounting the switcher
Furniture mounting the switcher
The MAV Series switcher models can be mounted under a table or other horizontal
surface with an optional Extron under-desk mounting kit (part #70-222-01).
1
.
Secure the two table/wall mounting brackets to the switcher with the eight
machine screws provided in the kit (figure 2-1).
2
.
Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the underside of the
desk.
3
.
Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
4
.
Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
5
.
Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
6
.
Slide the switcher slightly forward or back, then tighten all four screws to
secure it in place.