Extron Electronics MAV 44_48_84_88 Series User Guide - Manual (Page 41)

3-17 MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
Example 6: Save a preset
The following steps show an example in which the current configuration is saved
as a preset. The example shows the front panel indications that result from your
actions.
1 . Press and hold the Preset button for approximately 2 seconds until the Preset
LED begins blinking (figure 3-27).
PRESET PRESET
7 6 5 2 4 1
INPUTS
8 3 2 1 4 3
OUTPUTS
Press and hold the button.
2 seconds
= lit LED, = blinking LED, = unlit LED.
The LED blinks to indicate Save Preset mode.
Release the Preset button.
Preset 2
(Preset 2
assigned)
Preset 3 Preset 4 Preset 5
(Preset 5
unassigned)
Preset 9
(Preset 9
assigned)
Preset 10 Preset 11 Preset 12 Preset 6 Preset 7 Preset 8 Preset 1
All input and output buttons with assigned presets light. If you then save the configuration to a lit preset number,
the configuration data at that preset location will be overwritten.
Figure 3-27 — Enter Save Preset mode, MAV 84
2 . Press and release the Input 1 button (figure 3-28).
All LEDs but Input 1 and the Preset LED go out. The Input 1 LED and Preset
LED remain lit for 1 second to indicate the saved preset number and then go
out.
2 1 3
PRESET 2 4 1 3 4 3 4
OUTPUTS INPUTS
Press and release the Input 1 button to select preset 1.
Preset 2 Preset 3
All LEDs except the saved preset's LED go out.
The LED for the saved preset and the Preset LED
remain lit for 1 second then go out.
Figure 3-28 — Select the preset