Extron Electronics P-2 DA2 WM F, WM F AAP, EC F, D Setup Guide - Manual

Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D
This guide provides basic instructions for an experienced
installer to set up and operate the Extron ®
P/2 DA2 WM F, WM F AAP, EC F, D Series of
distribution amplifiers.
Installation
These distribution amplifiers are high performance one input, two output video devices with
audio that accept video input from a VGA-QXGA compatible PC and distributes that signal to
separately buffered outputs. Refer to the user manual for specific mounting instructions. An
example application for the P/2 DA2 D is shown below. Refer to the user manual for other
application and installation examples.
CO MP UT ER IN
MO NIT OR OU
T
AU DIO IN
Projector
Extron
MHR-5 Cable
PC w/ Audio
Extron
P/2 DA2 D
Distribution Amplifier
Audio
Audio
Output
Extron
MPA 122
Mini Power Amplifier
PO WE R
12V
3A MA X.
OU TPU
TS
4/8 Ohm s SP EAK ERS
INP UT S
L
R
L
R
RE MO TE
10V
VO L/M UT E
L
MP A 1 22
R
C
US
Extron
SI 3CT LP
Full-Range Ceiling
Speakers
C Installation and service must be performed by authorized personnel only.
Step 1 — Power down
Power off the display device, the PC and its local monitor.
Step 2 — Connect inputs
• For video input, connect the VGA output of the PC to the Input or Computer In 15-pin
HD connector on the faceplate of the distribution amplifier.
• For unbalanced stereo audio input, connect the input device
to the 3.5 mm female audio jack on the faceplate of the
distribution amplifier. Wire the audio plug as shown on the
right.
Step 3 — Connect outputs
• If a local monitor is being used, connect the monitor of the PC to the Buffered Local
Monitor or Monitor Out 15-pin HD output connector on the faceplate of the distribution
amplifier.
(Continued on reverse side)
Sleeve ( )
Ring (R)
Tip (L)