Setup guide — p/2 da2 wm f, wm f aap, ec f, d, Caution, Step 4 — set dip switches – Extron Electronics P-2 DA2 WM F, WM F AAP, EC F, D Setup Guide User Manual
Page 2: Step 5 — power up, Id pin 4 and id pin 11, Balanced stereo output
Setup Guide — P/2 DA2 WM F, WM F AAP, EC F, D
68-463-52
Rev. A
01 10
•
Connect the display device to the 15-pin HD connector on the rear panel of the
P/2 DA2 WM F, WM F AAP, EC F or to the 5 BNC connectors on the rear panel of the
P/2 DA2 D.
•
For audio output, connect the audio output device to the 3.5 mm direct insertion 5-pole
connector on the rear panel of the distribution amplifier. See the diagram below.
Unbalanced Stereo Output
Tip
NO GROUND HERE.
Sleeve(s)
Tip
NO GROUND HERE.
Balanced Stereo Output
Tip
Ring
Sleeve(s)
Tip
Ring
L
R
L
R
Left
Right
Left
Right
CAUTION
For unbalanced audio, connect the sleeve(s) to the center contact ground.
DO NOT
connect the
sleeve(s) to the negative (-) contacts.
Step 4 — Set DIP switches
Two sliding-type DIP switches can be found on the faceplate of the P/2 DA2 WM F,
WM F AAP, EC F. Refer to the user manual for setting the DIP switch for the D model.
To set these DIP switches, slide the switch to on/closed or off/open position.
The two DIP switches provide proper ID bit termination for a laptop computer that is not
attached to a local monitor. Also, see the note below regarding local monitor output and the
setting of internal jumpers.
ID Pin 4 and ID Pin 11
ON
– Set both pins to On if you are using the P/2 DA2 WM F, WM F AAP,
EC F with a laptop computer that is not attached to a local monitor.
OFF
– Set both pins to Off if you are attaching a local monitor to the
P/2 DA2 WM F , WM F AAP, EC F.
N
The jumpers inside the distribution amplifier are set at the factory for output
to a local monitor. However, you can direct output to a data display by resetting the
jumpers. Refer to the user manual for further details.
Step 5 — Power up
Connect the power supply cord of the distribution amplifier to a 100 to 240 VAC power source
and power up the local monitor, PC, audio and display device. See the wiring diagram below.
C
Always use a power supply specified by Extron for the distribution
amplifier. Use of an unauthorized power supply voids all regulatory
compliance certification and may cause damage to the power supply and
the distribution amplifier.
Power Supply
Output Cord
Captive Screw
Connector
3
5
SECTION A–A
Ridges
Smooth
A
A
Tie Wrap
C
Power supply voltage polarity is critical. Incorrect voltage polarity can
damage the power supply and the distribution amplifier. Identify the
power cord negative lead by the ridges on the side of the cord.
ID PIN 4
ID PIN 11