Extron Electronics USB Extenders User Guide User Manual
Page 22
Prepare the site and install the wall box
•
Choose a location that allows cable runs without interference.
•
Allow enough depth for both the wall box, the TP cable and power supply wiring. The
box should be at least 2.5 inches (6.35 cm) deep to accommodate the connectors and
cables.
•
Run the TP and power supply wires into the wall, furniture, or conduits before installing
the wall plate.
NOTE: The Decora series is designed to mount in a standard single-gang wall box.
1.6 in (4.1 cm)
1.4 in (3.6 cm)
One-Gang
Junction Box
2.5 in (6.4 cm)
TP Cable
(no boot)
Figure 10.
Wall Box Depth Profile, AAP and Decora
Final installation
Test the USB Extenders for proper operation, then:
1.
At the power outlet (not the extender), unplug the power supply.
2.
Mount the transmitter or receiver into the wall box.
3.
At the power outlet, reconnect the power supply.
USB Extenders • Reference Information
16