Extron Electronics RCP 2000 with ISS 506 Support Setup Guide - Manual (Page 3)

Selecting a cut (full screen program/preview swap)
To select a full screen cut transition (immediate and seamless replacement of the program image with the preview image),
1.
With the RCP in Wipe or Dissolve mode, select a preview input.
2. Press the Cut button. The selected preview image immediately becomes the program image.
Selecting a dissolve
To select a dissolve effect (the program image fades out while the preview image fades in),
1
. Select a preview input.
2 . Press the Dissolve button, which lights.
3 . While the Dissolve button is lit, rotate the Adjust knob to select the duration in seconds
(0.0 through 5.0) of the dissolve effect.
4 . Press Take to execute the dissolve effect.
N If you want to control the duration of the dissolve manually, move the T-bar handle up or down at the desired rate.
Using Picture Controls
The Picture Controls buttons, located near the
top of the front panel, let you adjust settings on
the preview output.
1
. Select a Preview input.
2 . Select a transition effect (wipe, PIP, title, or
dissolve).
3 . Press a picture control button.
4 . Rotate the H and/or V adjustment knobs, located to the right of the buttons, to select the values, as shown below.
Color/Tint
COLOR
TINT
V
H
Press
Adjust color
Adjust tint
Col Tint
064 064
Contrast/ brightness
CONT
BRIGHT
V
H
Press
Adjust contrast
Adjust brightness
Con Brt
064 064
Detail
DETAIL
V
H
Press
Adjust
sharpness
Detail
064
or
Pip Det
064
Image size
SIZE
V
H
Press
Adjust width
Adjust height
Hsz 1024
Vsz 0786
H W 0513
V W 0386
Wipe, dissolve, and title modes
PIP mode
H I 0513
V I 0386
Window size Image size
In PIP mode: Press the Size button
again to toggle between window
size and image size adjustment.
The Size button stays lit steadily
during window size adjustment
and blinks during image size
adjustment.
Centering
CENTER
V
H
Press
Adjust horizontal
position
Adjust vertical
position
Hsh 2048
Vsh 2048
H W 0640
V W 0480
Wipe, dissolve, and title modes
PIP mode
H I 0640
V I 0480
Window position Image position
In PIP mode: Press the Center button
again to toggle between window
position and image position.
The Center button stays lit during
window position adjustment and
blinks during image position
adjustment.
RCP 2000 with ISS 506 Support Setup Guide (cont'd)
COLOR
TINT
CONT
BRIGHT
SIZE CENTER DETAIL
PICTURE CONTROLS
H
V
DISSOLVE
Press
Rotate to
select dissolve
duration.
+
ADJUST
CUT
Press
RCP 2000 with ISS 506 Support • Setup Guide 3
N
Picture controls affect only the current preview input.
N If the current PIP or Title preview input is active on the program output, no
picture control adjustment is possible.
TAKE
Press