Extron Electronics MVX Plus 128 VGA A User Guide - Manual (Page 100)

MVX Plus 128 VGA A Matrix Switcher • Matrix Software 5-2
Matrix Software
PRELIMINAR
Y
Matrix Switchers Control Program
The Windows ® -based Extron Matrix Switchers Control Program communicates
with the switcher via the rear panel LAN port, the rear panel Remote RS-232/
RS-422 port, and/or the front panel Configuration (RS-232) port to provides an easy
way to set up ties and sets of ties. The program is compatible with Windows 2000
and Windows XP. Updates to these programs can be downloaded from the Extron
Web site (http://www.extron.com).
Installing the software
The program is contained on the Extron Software Products CD-ROM, disk B.
Install the software as follows:
N For full functionality, install both of the following programs:
• The Matrix Switchers Control Program
• The Firmware Loader
1 . Insert the CD-ROM into the drive. The installation program should start
automatically. If it does not self-start, run Launch.exe from the CD.
The Extron software CD window appears (figure 5-1).
Figure 5-1 — Software CD window
2 . Click the Software tab (figure 5-1).
3 . Scroll to the desired program and click Install (figure 5-2).
Figure 5-2 — Software installation