Extron Electronics VSC 300_300D User Guide - Manual (Page 13)

2-3 VSC 200/200D/300/300D Installation
Rear panel features
Figure 3 — VSC 200/200D rear panel
Figure 4 — VSC 300/300D rear panel
1 AC power connector — Standard AC power connector attaches the scan
converter to any power source from 100VAC to 240VAC, operating at 50 Hz or
60 Hz.
2 15-pin D connector — Mac input/loop out (loop through) computer video
connector.
3 15-pin HD connector — VGA input/loop out (loop through) computer video
connector.
4 75 ohm/Hi-Z switch — Provides termination for computer video input. Set
the switch to 75
Ω Ω Ω Ω Ω
if no local monitor is attached to the scan converter. Set the
switch to Hi-Z if a local monitor is attached.
5 Composite video output connector
6 Composite video LED (VSC 300/300D only) — Lights to indicate that the
composite video output is active.
7 Digital video output (ITU-R BT.601) connector (VSC 200D/300D only) —
Follows composite video out: If composite video is active, digital video is
active.
8 S-video output connector
9 S-video LED — Lights to indicate that the S-video output is active.
10 R/R-Y output connector — Red video output (RGB) or R-Y video output
(component video).
11 G/Y output connector — Green video output (RGB) or Y video output
(component video).
12 B/B-Y output connector — Blue video output (RGB) or B-Y video output
(component video).
13 H/HV output connector — Horizontal sync output (RGBHV) or composite
sync output (RGBS).
50/60 Hz 0.5A 100-240
INPUT/LOOP OUT OUTPUTS
G
E
N
L
O
C
K
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
OUT
H
HV
SOG
D1
IN
VGA MAC
RS-232
REMOTE
1 2 3 4 5 7
8
9 10 11 12 13
14
15 16
19
20 21
50/60 Hz 0.5A 100-240
G
E
N
L
O
C
K
VIDEO S-VIDEO R/R-Y G/Y B/B-Y H/HV V
OUT
H
HV
SOG
D1
IN
VGA VGA OUT MAC
INPUT/LOOP OUT OUTPUTS
RS-232
REMOTE
1 2 3 4 5
6
7
8
10 9 11 12 13
14
15 16 17 18
19
20 21