Extron Electronics YCS SW2 A User Guide - Manual (Page 11)

YCS SW2 A • Installation and Operation
Installation and Operation, cont’d
2-8 YCS SW2 A • Installation and Operation 2-9
Two tools are included with the PMK 450 kit:
• A set-screw hex wrench
• A security screw hex wrench
To projector-mount the YCS SW2 A using the PMK 450,
1.
Unscrew the front and rear plates and the security screws
from the sides of the PMK 450.
2 . Slide the top and bottom plates apart.
3 . Loosen the four pipe collar set screws to allow the top
plate to move freely along the pole.
4 . Ensure that the mounting pipe is installed with the cable
access hole facing the rear, away from the projector screen.
5 . Slide the top plate up the pipe until the pipe collar is
positioned just above the cable access hole. Ensure the rear
of the top plate is facing to the rear, in the same direction as
the cable access hole in the pipe.
FRONT
REAR
Pipe Collar and
Set Screws
Figure 2-8 — Positioning the top plate on the pipe
6 . Level the top plate and secure it by fully tightening the set
screws. At least three screws must come in contact with
the pipe.
7 . Route the cables for the devices to be mounted so that the
cables exit the pipe through the cable access hole.
4 . Repeat steps 2 and 3 on the other side of the YCS.
5 . Hold the unit with the attached brackets against the
underside of the table or other furniture. On the mounting
surface, mark the location of the bracket’s screw holes.
6 . Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.3 mm)
deep in the mounting surface at the marked screw
locations.
7 . Insert #8 wood screws into the four pilot holes. Tighten
each screw into the mounting surface until slightly less
than 1/4" of the screw head protrudes.
8 . Align the mounting screws with the slots in the brackets
and place the unit against the surface, with the screws
through the bracket slots.
9 . Slide the unit slightly forward or back, then tighten all four
screws to secure it in place.
Projector mounting using the PMK 450
The Extron PMK 450 Multi-Product Projector Mounting Kit (part
#70-618-02 or #70-618-03) can accommodate multiple Extron
products of various sizes and their power supplies.
Rear Plate (1)
Pipe Collar (1) and
Set Screws (4)
Security Screw (2)
AC Power Cord
Access Slot
1 2
VID EO
VID EO
AU DIO
S-VI DE O
CO NT AC T
AU TO -SW
PO WE R 12V 0.4 A M AX
INP UT S OU TPU T
1
1 INP UT S OU TPU T
2
2
L
R
R
L RE MO TE
Bottom Plate (1)
Filler Plate (1)
Front Plate (1)
Top Plate (1)
Extron
YCS SW2 A
Transcoding
Switcher
Figure 2-7 — Components of the Extron PMK 450 kit