Imetec SILENT POWER COMPACT - Manual (Page 14)

EN
12
ATTENTION! The vacuum cleaner has a motor protection thermostat,
which intervenes in the case of overheating (caused by the inlet opening,
filters, etc. being clogged). If it is triggered, press the ON/OFF button
to switch the appliance off and let it cool down for a few hours. Verify
whether dust has clogged the filters or the inlet opening before restarting
the appliance.
ASSEMBLY
• Connect the flexible suction pipe (10) to the inlet connection (7) of the appliance.
Pay attention when setting the buttons to fasten the suction pipe (10A); it is fastened
correctly when it snaps into place [Fig. B1].
• Connect the handle (8) of the flexible suction pipe (10) to the adjustable telescopic pipe
(11). Adjust the length of the adjustable telescopic pipe (11) by pressing the adjustment
button (11A) in the direction of the arrow and removing or retracting the telescopic pipe
[Fig. C1].
• Select the combination brush (12) or the attachment (13) suited to the surface to be
cleaned and connect the adjustable telescopic pipe (11).
ACCESSORIES
Combination carpet/floor brush (12)
Adjust the combination brush according to the type of flooring, using the toggle switch (12A)
[Fig. D1]:
• toggle switch (12A) with the symbol
(extended bristles) upwards: for hard
flooring;
• toggle switch (12A) with the symbol (retreacted bristles) upwards: for rugs and
carpets.
Your appliance is equipped with the following attachments:
Crevice tool (13A): to clean corners and crevices, such as radiators, skirting boards and
blinds.
Dusting nozzle (13B): to clean small objects, audio and TV appliances, computers and
furniture.
Upholstery nozzle (13C): to clean sofas, armchairs, upholstered chairs and curtains.
Parquet brush (13D): a special brush to clean parquet flooring.
NOTE:
• The accessories can be connected to the adjustable telescopic pipe (11) or
directly to the handle (8).
USE
Pull the power cable (15) completely, up to the red mark, and insert the plug into the socket.
The yellow mark indicates the end of the cable [Fig. F1].
MI000956_corretto.indd 12 18/12/2012 17:36:11