Imetec INTELLIVAPOR ECO - Manual (Page 17)

EN
15
END OF USE
Switch the appliance off by pressing the ON/OFF button (3).
• Disconnect the plug (4) from the socket.
• Wait for the appliance to cool down completely before putting it away. The reservoir (1)
does not have to be emptied.
NOTE:
If the appliance is not to be used for several weeks, remove and empty the water
reservoir (1) completely.
TROUBLESHOOTING
This chapter describes the most common problems that can arise using the appliance. If the
problems cannot be solved with the information below, please contact the Authorised
Assistance Centre.
Problem Possible cause Solution
The appliance does not turn on. The household appliance is not on.
Ensure that the appliance is properly
connected to the socket, that the ON/
OFF button (3) is pressed and the light
is on.
The plate temperature LED (11)
goes on and off.
Normal procedure.
The switching ON and OFF of the LED
(11) indicates the heating phase of the
iron. The LED goes off once the set
temperature is reached.
Smoke comes out of the
appliance when it is switched on
for the first time.
This is absolutely normal and is
due to the expansion of the plastic
material.
This no longer occurs after a while.
Impurities come out of the plate
(12).
This is perfectly normal in a new
iron.
These particles are completely harmless
and will disappear after the iron is used
a few times.
The appliance does not produce
steam.
The appliance is not on. Press the ON/OFF button (3).
The steam button (13) is not being
pressed.
Keep the steam button (13) pressed as
you iron.
The water in the reservoir (1) has
finished and the no water LED (8)
is on.
Fill the water reservoir (1) (see chapter:
FILLING THE RESERVOIR WHILE
IRONING).
The water reservoir (1) is not
positioned correctly on the boiler
and the no water LED (8) is on.
Position the reservoir by making it slide
on the guides until it clicks into position.
The boiler cleaning LED (7)
continues blinking even after it
has been cleaned.
The ECO button (5) was not held
down long enough.
Hold the ECO button (5) down until the
LED goes off.
The plate (12) is dirty: there are
impurities or limescale residues.
The impurities or chemical
substances found in the water
have deposited on the plate.
Wait for the plate to cool down and clean
it with a damp cloth.
You are ironing at a temperature
that is too high.
Wait for the plate to cool down and clean
it with a damp cloth.
An excessive amount of limescale
and minerals has accumulated in
the boiler.
Clean the boiler (see the CLEANING
THE BOILER chapter).