IPX DDK-1800 - Manual (Page 13)

2.4 Updating System Software
If the system software of the DDK-1800D needs to be upgraded, follow these steps
Important: Before carrying out this procedure, please ensure the SD card is working and the
file of the system firmware is intact
1. Create a directory with the name DDK-1800D on the SD card if it does not already exist.
2. Copy the file UPDATE.BIN to the DDK-1800D -directory.
3. Shut down DDK-1800D’s power.
4. Insert the SD CARD into the DDK-1800D.
5. Remove the Ethernet cable from the RJ-45 port and then power on camera.
6. Within 5 to 10 seconds, a message reading "UPDATE PROCESSING" will show up on the
screen in a blue background. DO NOT power off the DDK-1800D while update process is
running until the message "UPDATE OK RESET PLEASE" appears on the screen. This may
take 15 to 30 seconds to appear.
7. If the message "UPDATE NG RESET PLEASE" appears, write down the error messages
shown on the screen and contact manufacturer. Power off the DDK-1800D when the update
process is finished and then remove the SD card from the camera.
8. Reconnect the Ethernet cable to the RJ-45 port. Power ON the IP camera.
9. Verify the version of the system software.
WARNING :
If the power of the DDK-1800D is suddenly lost in step 7, remove the SD card first and
then power the camera on. If the DDK-1800D operates normally repeat step 3.
Otherwise contact the manufacturer.
If the message "CSUM ERROR" appears in step 7, there is a problem with the
UPDATE.BIN file. .
13