Andrew James AJ000285 6 Day Pet Feeder - Manual (Page 7)

7
General Operation
Filling the bowl with Food
1. Disassemble the appliance according the section “Disassemble”.
2. Fill the feeder base (D) trays 1-6 with food.
3. Re-assemble the appliance according to the sections “Re-assembling the
appliance ”
Setting the current Clock Time
1. During Clock display mode, press and hold the SET key for (2 seconds) to
enter Clock SET mode. The hour number will now be blinking.
2. Press the MODE key to increase the hour. Once you have set the hour, press
the SET key to confirm the hour. The minute number will now blink.
3. To change the minute number, press the MODE key to increase the minute.
Once you have set the minute, press the SET key to confirm the minute.
Both the hour and minute numbers will now blink.
4. If needed, Press the MODE key to change between 12 or 24 hour time.
5. Press the SET key to confirm your current time setting and the numbers will
stop blinking.
Setting the Feeding Time
1. After setting the clock time, press the MODE key one time. (1 1) will show
on the display. This is feeding time display mode.
2. Now press and hold the SET key for (2 seconds) to enter Feeding-time SET
mode. Feeding will start from the first feeding number & time. The 1
st
digit
represents the feeding number (Food Tray 1)
3. The hour digits will now blink (2
nd
and 3
rd
digit). Press the MODE key to
increase the time, then press the SET key to confirm the time you set.
4. After confirming the 1
st
feeding time, the next feeding number & time will
show on the display. (1
st
digit will change to the next feeding number, e.g.
Food Tray 2 or 3 or 4 or 5 or 6 and back to 1) To change the feeding time,
repeat step 3.
5. Repeat step 3 until all 6 feeding times for each Food Tray are set. The display
will change back to clock display mode when all 6 feedings have been set.
1
st
dig- 2
nd
dig- 3
rd
dig-
Feeding
Number
Feeding
Time