GEARENCH SCT614H PETOL SURGRIP™ Casing Tong - Manual (Page 15)

13
Material Qualifications
The following table is a list of the materials and grades used in the manufacture of the
SCT614H Surgrip Casing Tong.
Note: Yield and tensile strengths are post heat treat. Parts are heat treated after machining.
Part
Number
Description Material Yield
Strength
(min)
Tensile
Strength
(min)
Impact
@-4°F
(min)
Reduction
of Area
(min)
SCTH614H Handle AISI 4318 110 ksi 120 ksi 31.0 ft-lb 25 %
SCTJ614H Jaw AISI 4318 110 ksi 120 ksi 31.0 ft-lb 25 %
HP410 Pin AISI 4140 165 ksi 180 ksi N/A N/A
HI09D Insert AISI M2 N/A N/A N/A N/A
HP411 Pin AISI 4140 165 ksi 180 ksi N/A N/A
HP412 Pin AISI 4140 165 ksi 180 ksi N/A N/A
HH19 Hanger ASTM A148
Gr. 90-60
60 ksi 90 ksi N/A N/A
SCTB614H Belt Aramid-
Polyurethane
Composite N/A N/A N/A N/A